Onebom Hose Splitter 3/4 Inch, Solid Brass Pipe Connector,Garden Hose Distributor Heavy Duty (4 Way)

Haven't had it very long but so far I've had no issues is working better than the solid brass one I had. Seems to be well made. The individual water controls are a good size and turn the water off and on easily. it does the job it was designed to do.The knobs turn with little effort with no leakage. So far I' impressed. Believe me that's not often.Setup for spraying garden, plants and lawn at the same time.Definitely would buy this again.

broken can't withstand any cold not freezing but cold weather. no way to fix it , it's junk waste of money that I don't have. and no warranty.Had hoped that this would be better than plastic. Plastic ones lasted much longer.

This product works as advertised, but generally only lasts about a year. It's a good thing they are inexpensive. Works well until they start leaking. Don't expect a long life with this product.

I used this to replace my outdoor faucet with two hoses with sprinklers. I alternate between them, so it is convenient for the separator to allow independent closing of each valve. It works clean and turns off the water completely. Although the device itself is solid metal, the switches are heavy plastic, so I'm a bit worried that they won't last very long, but if there are any problems, I'll update

This hose splitter is great. It fits the faucet well and does not leak. It is very handy to be able to leave a hose connected and out on the lawn, but still have access to water from another opening. This splitter pivots on the faucet to the proper angle and can then be tightened so that it stays there. Easy to install and easy to use. It came with several hose washers and some Teflon tape. I did not need to use the Teflon tape.

We were very happy with this product. Was exactly as shown and works great! We use one in the front yard and one in the back yard. Easy to install and use.

Seemingly well-built. 1 week after installation, one of the 3 valves started spraying water and could not seal even under the lowest amount of pressure. Close examination revealed that the internal threads between the lower brass fitting and the body were damaged. This part should never even be exposed. There were enough metal bits inside to etch the plastic valve seating, and so the water was getting through no matter the position of the valve control. No idea if this was a single unit defect or a brand-wide problem with quality control.

Thank goodness some things are still made out of good hard metal. This connector is durable and will last a long time. Worth the money.