Deliver to UAE
IFor best experience Get the App
AZDelivery 3 x ST-Link V2 Emulator Mini Debugger and Programming Unit STM8 STM32, Aluminium Casing 3.3V 5V Downloader Programmer Support with F2F Jumper Wire compatible with Arduino including E-Book!
Description
- ✅ Get a three-piece deal of the AZDelivery ST Link V2 Programmer at a special quantity discount price. The ST Link V2 Programmer supports the full range STM32 SWD debugging interface.
- ✅ Supports automatic firmware upgrades to ensure the aftercare of ST products. The factory firmware has been updated to the latest version V2.J17.S4.
- ✅ Pinout printed directly on the case which makes wiring simple and clear. USB 2.0 full speed compatible interface, 2x5 male header pins with 0.1in (2.54mm) spacing, 4 F2F 20 jumper wires included
- ✅ Internal board with 500MA self recovery fuse to protect your motherboard. It supports 3.3V and 5V power output, and all output I/O ports are protected from operational errors. Water proof and static electricity safe
- ✅ This product includes an E-Book that provides useful information on how to begin your project, it helps with a quick setup and saves time on the configuration process. We provide an array of application examples, full installation guides and libraries.
Full description not available
Reviews
M**O
4 out of five are working
None of the five units would work with the current ST Link programer for STM as they were all loaded with V2J17S4 firmware and the programmer said they needed upgrading. After a bit of messing around I did get them to update to latest firmware V2J37S7 however after update one unit decided to play up reporting its serial number as 1 and it will not connect nor will it take the upgrade . So 4 out of 5 working and all of them way out of date with supplied firmware. So one star off for needing to upgrade and one star off for the faulty one, you can find a manual (ST-Link V2 USB Dongle Programmer_EN.pdf, 18 pages) on their main site if you search for the product. That gives some good information on using the dongle with the Arduino IDE, I was using the offical STM32 Cube Programmer which requires the upgrade to work.Sliding the cover off allows you to check the chip ID mine are using the STM32GC102CB chip, these are pretty old chips as the older Nucleo boards use the STM32F103 and the V3 boards use the STM32F723.That said it is still a good price for a programmer even with only four out of five working..
P**L
2 out of 3 worked fine
About what I expected. Two out three work fine the third one does not work, when I get some spare time I will investigate.Peter
Common Questions
Trustpilot
1 week ago
3 days ago
Get the App
